PrécédentTable des matière Suivant
 

4.11.14 IBM-AIX

Automatic detection of xlC is missing from Autoconf, so a configure command something like this is needed when using the IBM compiler: 

shell> CC="xlc_r -ma -O3 -qstrict -DHAVE_INT_8_16_32" \
       CXX="xlC_r -ma -O3 -qstrict -DHAVE_INT_8_16_32" \
       ./configure

If you are using egcs to compile MySQL, you MUST use the -fno-exceptions flag, as the exception handling in egcs is not thread-safe! (This is tested with egcs 1.1.) We recommend the following configure line with egcs and gcc on AIX: 

shell> CXX=gcc \
       CXXFLAGS="-felide-constructors -fno-exceptions -fno-rtti" \
       ./configure --prefix=/home/monty --with-debug --with-low-memory

If you have problems with signals (MySQL dies unexpectedly under high load) you may have found an OS bug with threads and signals. In this case you can tell MySQL not to use signals by configuring with: 

shell> CFLAGS=-DDONT_USE_THR_ALARM CXX=gcc \
       CXXFLAGS="-felide-constructors -fno-exceptions -fno-rtti -DDONT_USE_THR_ALARM" \
       ./configure --prefix=/home/monty --with-debug --with-low-memory

This doesn't affect the performance of MySQL, but has the side effect that you can't kill clients that are ``sleeping'' on a connection with mysqladmin kill or mysqladmin shutdown. Instead, the client will die when it issues its next command.

Table des matières
PrécédentNexen.netSuivant